DMP Electronics SCS2 Manual do Utilizador descarregar pdf (Página 34)

JTAG-Booster for AMD ÉlanSC520

34 JTAGEL5d.doc

2.2. Read a Flash Device to file

Usage: JTAGEL5 /R filename [optionlist]

The contents of a flash device is read and written to a file.

The type of flash device is normally detected by the software. When autodetect

fails you should use the /DEVICE= option to set the right flash device. The known

devices are shown in chapter 1.7 “Supported flash devices”.

Options:

/DEVICE=devicename

See function /P (Chapter 2.1)

/NOMAN

See function /P (Chapter 2.1)

/DEVICE-BASE=hhhhhh

See function /P (Chapter 2.1)

/OFFSET=hhhhhh

Reading of the flash memory starts at an offset of hhhhhh relative to the start

address of the flash device. If the offset is negative, the offset specifies a address

relative to the end of the flash device.

See also option /TOP.

Default: /OFFSET=0

Abbreviation: /O=

/TOP

If the option /TOP is used the option /OFFSET= specifies the address where

reading ends (plus one) instead of the starting address.

/LENGTH=hhhhhh

The number of read bytes may be limited to LENGTH. If no LENGTH is specified

the whole flash device is read (if no offset is specified).

hhhhhh=number base is hex

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 50 51

Sem comentários

DMP Electronics SCS2 Manual do Utilizador Página 34